www.acr-asia.com
Home Products About us Contact us Links  
 
   - A   + A
Search :
| MGD | IAM | ST-IAM | Housing available | Sensor available |

MURCO GUIDE LINE

Sensors must be powered according to the instruction manual and be within the cable length from the control unit.
  •  
  • Do not mount in areas of high heat, direct solar heat, wetness, dampness, or where condensation may form.
  •  
  • Do not mount to piping or any structure subject to vibration.
  •  
  • For perimeter detection, place sensors around the area in question to monitor the entire space.
  •  
  • For point detection, place a sensor(s) at a point where you are concerned about a leak, i.e. at the compressor.
  •  
  • For heavier than air gases, place sensors close to the ground.
  •  
  • For lighter than air gases, place sensors high on the walls or ceiling, but convenient for maintenance.Note: Ammonia is lighter than air at normal temperature but heavier in a cold room.
  •  
  • Take room shape into consideration and mount sensors downstream of any air flow.
  •  
  • In hot rooms, hot air rises to form a barrier below the ceiling and prevents gas from getting to a ceiling-mounted sensor.


       
    www.acr-asia.com HomeProductsAbout usContact usLinks
      Web hosting | website builder |䫵ٻ by ninenic ©Copyright 2002-2017 All rights reserved.
    AC&R
    Email : acr@acr-asia.com